Stanhard 550 Abrasion Resistant Wear Plate Manufacturer & Supplier
Stanhard 550 is a low-alloyed quenched & tempered martensitic wear plate with a nominal hardness of 525-575 HBW. It combines abrasion resistance with the formability, weldability and toughness needed for fabricated wear parts.
UNS: 525-575 HBW | Category: Abrasion Resistant Wear Plate
Size Range
Outer Diameter: Thickness 4-100 mm · Width 1250-3000 mm · Length 4000-14000 mm
Wall Thickness: 6 - 75 mm
Chemical Composition (%)
| C | Si | Mn | P | S | Cr | B |
|---|---|---|---|---|---|---|
| 0.32 max | 0.80 max | 0.60 max | 0.015 max | 0.003 max | 0.80 max | 0.006 max |
Mechanical Properties
- Hardness
- 525-575 HBW
- Yield Strength Rp0.2
- 1400 N/mm² (typical, 2.5-12 mm)
- Tensile Strength Rm
- 1800 N/mm² (typical, 2.5-12 mm)
- Elongation A5
- 10.0%
- Impact Strength KV -20 °C
- 22 J
- CEV
- 0.85 / 0.86
- Yield Strength (20 mm ref.)
- 1400 MPa min
- Tensile Strength (20 mm ref.)
- 1400 MPa min
- Elongation (GL 50 mm, 20 mm ref.)
- 7%
- Charpy V-notch (20 mm ref.)
- 20 J @ -40 °C
Physical Properties
- Density
- 7.85 g/cm3
- Modulus of Elasticity
- 210 GPa
- Thermal Conductivity
- 40 W/m-K (20 C)
- Specific Heat
- 460 J/kg-K
- Coeff. of Thermal Expansion
- 12 um/m-C (20-200 C)
- Magnetic
- Ferromagnetic
Applicable Standards
- EN 10029:2010 (thickness/width/length)
- EN 10029 Class N steel type H (flatness)
- EN 10163-2 Class A Subclass 1 (surface)
- EN 10160 SO/EO (ultrasonic)
Applications
- Dump truck bodies & tipper liners
- Excavator buckets & bucket teeth
- Front loader buckets
- Crusher liners & jaw plates
- Chutes, hoppers & skirt boards
- Conveyor & screen wear strips
- Mill liners
- Recycling & shredder plate
Industries Served
- Mining
- Quarrying & Cement
- Construction & Earthmoving
- Material Handling
- Process Industries
- Recycling
Key Advantages
- Through-hardened — wear life holds as the plate wears down
- Cut, formed and welded without re-hardening afterwards
- Lets you run thinner section than mild steel at the same life
- Supplied flat and within EN 10029 tolerance for clean nesting
- Hardness reported to DIN EN ISO 6506-1 on every heat
Equivalent Grades
- SSAB
- Hardox 550
- Nippon Steel
- Abrex 500DT